Skripsi

IDENTIFIKASI KERUSAKAN PADA BANTALAN DENGAN MENGGUNAKAN SENSOR ACCELEROMETER ADXL 345

---

Penilaian

---

To minimize the damage that occurs suddenly in industrial engine, the planning of the treatment should be prepared as good as possible. One way of detecting the damage of an equipment system is by analyzing the characteristics of vibration that caused by the system. It is needed a vibration measuring instrument to measure the vibration. The vibration measuring instrument is not a cheap tool, and can only be reached by the middle industry group and up. Therefore, the vibration measuring instrument which is much cheaper and can be used to detect damage in an engine is needed. The vibration measuring instrument used is composed of MEMS Accelerometer ADXL 345 sensor, microcontroller Arduino UNO, and is programmed using MATLAB software. This measuring instrument is used to detect the bearing defect. From the result of the analysis it is found that the vibration in normal and defective bearing shows the characteristic of different spectrum in the radial direction which is x and y. In the axial directed of z-axis the response of vibration signal is not detected. In defective bearing condition, signal characteristics from FFT spectrum has various amplitude vibration value in the range of frequency 23-33 Hz with the highest value of amplitude vibration are 0,35g and 0,43g.

---

Availability

Inventory Code	Barcode	Call Number	Location	Status
1707006159	T16871	T168712017	Central Library (References)	Available but not for loan - Not for Loan

Detail Information

Series Title

-

Call Number

T168712017

Publisher

Inderalaya : Prodi Teknik Mesin, Fakultas Teknik Universitas Sriwijaya., 2017

Collation

xxvii, 51 hlm. : ilus. ; tab. ; 28 cm

Language

Indonesia

ISBN/ISSN

-

Classification

620.004 07

Content Type

Text

Media Type

-

Carrier Type

-

Edition

-

Subject(s)

Prodi Teknik Mesin
Pengujian Mesin Industri

Specific Detail Info

-

Statement of Responsibility

DS

Other version/related

File Attachment

Comments

---

You must be logged in to post a comment