Skripsi

UJI PENGARUH KELENGKUNGAN SINGKAL TERHADAP HASIL PENGOLAHAN TANAH ULTISOL DENGAN BERBAGAI KECEPATAN KERJA

---

Penilaian

---

The research objective was to determine test of the effect of curvature moldboard on the ultisol soil tillage with various working speed. The method used was Factorial Randomized Block Design which consist two treatment factors, namely the angle of curvature of the plow (A) and the working speed (B). Each factor consists of three levels of treatment. The treatment level for the angle of curvature consisted of the angle of curvature 120ᵒ, 130ᵒ, and 140ᵒ while the treatment level for the working speed of the plow consisted of a working speed of 2 km/hour, a working speed of 3 km/hour, and a working speed of 4 km/hour. The results showed that the angle of curvature of the moldboard and the working speed of the plow significantly affected the yield of ultisol soil tillage, with the combination treatment of the angle of curvature of the moldboard 140ᵒ and the speed of 4 km/hour producing the lowest average soil stickiness of 104.63 g while the combination of treatment with the angle of curvature of 120ᵒ and a speed of 4km/hour resulted in an average moldboard working depth , height of plowed soil (cm), moldboard cutting width , and the highest inverted land width was 11.67 cm, 11.00 cm, 16.67 cm, and 20.33 cm, respectively.

---

Availability

Inventory Code	Barcode	Call Number	Location	Status
2207000637	T66134	T661342022	Central Library (Referens)	Available but not for loan - Not for Loan

Detail Information

Series Title

-

Call Number

T661342022

Publisher

Indralaya : Prodi Teknik Pertanian, Jurusan Teknologi Pertanian, Fakultas Pertanian Universitas Sriwijaya., 2022

Collation

xvi, 36 hlm.: ilus.: 29 cm

Language

Indonesia

ISBN/ISSN

-

Classification

631.510 7

Content Type

Text

Media Type

-

Carrier Type

-

Edition

-

Subject(s)

PENGOLAHAN TANAH
Prodi Teknik Pertanian

Specific Detail Info

-

Statement of Responsibility

MURZ

Other version/related

File Attachment

Comments

---

You must be logged in to post a comment